DADE Holesaw dust and debris eliminator

The D.A.D.E. Dust & Debris Eliminator

We all know the way that downlights are installed we mark the hole check for no obstructions and then we use a hole saw to cut the hole. We don’t want to use special tools with spinning blades that take a time to set up, wear out quickly and are far slower than our hole saws.

The DADE simply fits between the holesaw and the drill chuck. 

• It has two patented debris collecting channels that collect the debris, stopping it from damaging the drill and the surrounding area.
• Manufactured from non-marking silicon.
• It has a patented nylon base that allows the drill to rotate freely with no Resistance.
• It will work with hole saws up to and including 120mm, catering for most downlights that are installed in today’s market.

Q&A:

• Q. WHAT SIZE HOLE SAW DOES THE DADE GO UP TO?
• A. The DADE will work with hole saws up to and including 120mm
• Q. CAN YOU USE THE DADE ON DOUBLE SKIN PLASTERBOARD? 
• A. Yes, the DADE will work on double skin plasterboard.
• Q.WHAT TYPE OF HOLE SAW AND ARBOR WILL THE DADE WORK WITH? 
• A. The DADE will work with multi-purpose hole saws, and many arbors. However as the saws and arbors continually change it is best to check before you purchase.
• Q. DO YOU DO A BIGGER DADE?
• A. No. The current market does not make it viable to produce a bigger DADE.
• Q. HOW DO I USE THE DADE?
• A. The hole saw sits in the DADE and you put the spindle of the hole saw into the drill chuck as normal. Just make sure that the DADE rotates freely before use.

Take a look here at it's usage, free from dust and debris when you drill: